eprintid: 66678
rev_number: 1
eprint_status: archive
userid: 1
dir: disk0/00/06/66/78
datestamp: 2026-05-26 15:56:33
lastmod: 2026-05-26 15:56:33
status_changed: 2026-05-26 15:56:33
type: article
metadata_visibility: show
sword_depositor: 1
creators_name: Shukhrat, Ishmuradov
creators_name: Solih, Khudoyberdiev Muhammad
creators_name: Rustamjon, Abdumajidov
title: EXPERIMENTAL RESULTS ON THE INFLUENCE OF THE INSTALLATION ANGLES OF THE SUPPORT DISC MOUNTED ON A DISC PLOW RELATIVE TO THE VERTICAL ON THE PLOW’S PERFORMANCE INDICATORS
ispublished: pub
subjects: Support disc device, installation angle of the support disc relative to the vertical, actual working width of the plow, design working width of the plow, root mean square deviation of the plow working width, surface roughness height of the furrow, specifi
keywords: Support disc device, installation angle of the support disc relative to the vertical, actual working width of the plow, design working width of the plow, root mean square deviation of the plow working width, surface roughness height of the furrow, specific draft resistance of the plow, operating speeds.
note: Imported from MJST Journal (OAI id oai:ojs.pkp.sfu.ca:article/7332)
abstract: This article presents the experimental results on the influence of the installation angles of the support disc relative to the vertical on the performance indicators of a plow. It was determined that when the installation angle of the support disc relative to the vertical is 0°, the supporting surface is insufficient. As a result, during inversion plowing, the actual working width of the plow exceeds the design working width by 5.1 cm and 8.2 cm, respectively. At this angle, the plow operates with lateral deviation. When the installation angle of the support disc relative to the vertical is in the range of 10° to 20°, the plow operates without lateral deviation, and therefore its actual working width does not significantly exceed the design working width. However, when the installation angle increases from 20° to 30°, the support disc does not sufficiently rest on the bottom of the furrow, which leads to an increase in the plow’s working width.
date: 2026-05-06
date_type: published
publisher: Center for Tech and Media Research
official_url: https://mjstjournal.com/index.php/mjst/article/view/7332
id_number: oai:ojs.pkp.sfu.ca:article/7332
full_text_status: none
publication: Multidisciplinary Journal of Science and Technology
citation:   Shukhrat, Ishmuradov, Solih, Khudoyberdiev Muhammad, Rustamjon, Abdumajidov  (2026) EXPERIMENTAL RESULTS ON THE INFLUENCE OF THE INSTALLATION ANGLES OF THE SUPPORT DISC MOUNTED ON A DISC PLOW RELATIVE TO THE VERTICAL ON THE PLOW’S PERFORMANCE INDICATORS.  Multidisciplinary Journal of Science and Technology.